Ubox ALU 200A manual

Ubox ALU 200A is similar to our Ubox ALU 100A with further higher current capability, by double the MOSFETS and extend the size. 'ALU' is mean for aluminum substrate power stage.

Buy link:

Features

1. Three low side shunts, 0.5 milliohm x 3.
2. Phase filters.
3. 100V 300A x 12 N-MOSFETS.
4. 12AWG X 2 silicon wires for battery and motor phases.
5. 12V 4A (at 70V) for external devices, such as cooling fan, lights, horn, screen, etc. With recoverable fuse.
6. 5V 3A with recoverable fuse.
7. 3.3V 500mA with recoverable fuse, independent from MCU's.
8. Built in BMI160.
9. Power button with green and red LEDs, copy the VESC status LEDs.
10. Ignite/voltage meter support.
11. 12V Fan socket.
12. Separated 4 pin 12V socket.
13. Less than 200uA off state current.
15. Size：139x76x24mm without ears, 139x91x24mm with 4 ears.

The double wires of Ubox ALU 200A

This controller can only accept a single battery/power source, you can fork it to two sub-routes through the two +&- wire couples, if one couple can't bear the current.

Don not plug two batteries to the controller, it can not make your two batteries serialized, only connect them together directly, will cause seriously inter-charge, cause fire and explosion.

So do the phase wires. Phase wires can only serve to one motor, do not try to run two motors with one controller.

Two or more wheel driving configuration

As same Ubox ALU 100A: Ubox_ALU_100A_manual

Limits and cautions

1. This is an electronic power product. Installation and use requires certain knowledge of electronic circuits and and cautious. The first thing to do before connect to battery or power source is to double check whether the positive and negative wires are correctly connected.
2. The Ignite socket is often too high to be safe, Don not plug the power button in it.
3. This product is for DIY purpose, so we only offer a very limited warranty.

See also

Main Page