Difference between revisions of "Adapter V2 manual"

From Spintend service and support
Line 18: Line 18:
Hold both the right and left brake handles then power on the system, the adapter will toggle the 2/1 drive mode, after the switching, the buzzer will ring once for 1 wheel mode, and twice for 2 wheel mode.
Hold both the right and left brake handles then power on the system, the adapter will toggle the 2/1 drive mode, after the switching, the buzzer will ring once for 1 wheel mode, and twice for 2 wheel mode.


The principle of 2 wheel drive is to copy the control signal from main ESC to the second ESC. In order to implement this function, the internal CAN bus connection need to set off, for Ubox, please refer:  [[The power button of Ubox]].
The principle of 2 wheel drive is to copy the control signal from main ESC to the second ESC. In order to implement this function, the CAN bus connection of two ESCS need to set off, for Ubox, please refer:  [[The power button of Ubox]].


===Power limit mode===
===Power limit mode===

Revision as of 10:13, 23 March 2022

This is the manual of HW V02, the newer hardware version is in progress, waiting our users to feedback.

The V2 adapter is designed to make convenient for users to connect wires of e-bike/e-scooters to the VESC.

Features

  1. Horn, head light, turn light, brake & rear light, and reverse light support.
  2. High, middle, low, 3 level throttle support.
  3. Support both hall brake and mechanical brake input.
  4. Two / one wheel drive support.
  5. Power limit for compliance to the regulations.

Wiring

Mode switching

Adapter V2 has 2 mode switching: 2/1 wheel drive mode switching and power limit mode on/off.

2/1 wheel drive mode

Hold both the right and left brake handles then power on the system, the adapter will toggle the 2/1 drive mode, after the switching, the buzzer will ring once for 1 wheel mode, and twice for 2 wheel mode.

The principle of 2 wheel drive is to copy the control signal from main ESC to the second ESC. In order to implement this function, the CAN bus connection of two ESCS need to set off, for Ubox, please refer: The power button of Ubox.

Power limit mode

Hold both the left brake handle and the throttle handle bar, then power on the system, the adapter will toggle the power limited/unlimited mode, after the switching, the buzzer will ring three times for unlimited mode, and twice for limited mode.

The principle of Power limit mode is to scale the throttle handle bar's input to the L level, ignore the H, M, L state.

Setup in VESC tool

Caution and limits

See also

Main Page