Ubox ALU 100A manual

Ubox ALU 100A is .

Buy link:

Features

1. Three low side shunts, 0.5 mohm x 3.
2. Phase filters.
3. 12V 3A for external devices, such as cooling fan, lights, horn, screen, etc. With recoverable fuse.
4. 5V 1A with recoverable fuse.
5. 3.3V 500mA with recoverable fuse, independent from MCU's.
6. Built in BMI160.
7. Power button with green and red LEDs, copy the VESC status LEDs.
8. Ignite/voltage meter support.
9. 12V Fan socket.
10. Separated 4 pin 12V socket.

Two or more wheel driving configuration

Ubox ALU 100A has a 'PWR.ON' pin in the CAN socket:

This PWR.ON pin can accepts a 5V signal to make power on the Ubox ALU 100A, then the 12V power source of this Ubox will working, consequently the 5V and MCU's 3.3V (3.44V actually) will on. There for we can get all of the 12V power from each Ubox, which is 6A total for two wheel driving, 12A for four wheel driving.

To config a 2WD/4WD, we need to move the 5V wire of the CAN cable to the PWR.ON pin for the slave (follower) Ubox:

The master Ubox side no need to change:

The whole 2WD configuration:

For 4WD configuration, make each followed Ubox's PWR.ON pin receives the 5V signal from its predecessor.

What if I want them running independently? We can pick out the the CAN-H and CAN-L wires from the CAN cable, only keep the GND and 5V wires remain.

Limits and cautions

1. This is an electronic power product. Installation and use requires certain knowledge of electronic circuits and and cautious. The first thing to do before connect to battery or power source is to double check whether the positive and negative wires are correctly connected.
2. Although the MOSFETS and the the driving circuit are can working beyond 80V, but the internal TVS is 78V nominal, so E-fuse can not be used beyond 80V.
3. The Ignite socket is often too high to be safe, Don not plug the power button in it.
4. This product is for DIY purpose, so we only offer a very limited warranty.

See also

Main Page