Ubox ALU 100A manual

From Spintend service and support
Revision as of 19:54, 24 February 2023 by John (talk | contribs)

Ubox ALU 100A is .

Buy link:

Features

  1. Three low side shunts, 0.5 mohm x 3.
  2. Phase filters.
  3. 12V 3A for external devices, such as cooling fan, lights, horn, screen, etc. With recoverable fuse.
  4. 5V 1A with recoverable fuse.
  5. 3.3V 500mA with recoverable fuse, independent from MCU's.
  6. Built in BMI160.
  7. Power button with green and red LEDs, copy the VESC status LEDs.
  8. Ignite/voltage meter support.
  9. 12V Fan socket.
  10. Separated 4 pin 12V socket.

Ports and wiring

The button and ignite

Concludes and explains

Limits and cautions

  1. This is an electronic power product. Installation and use requires certain knowledge of electronic circuits and and cautious. The first thing to do before connect to battery or power source is to double check whether the positive and negative wires are correctly connected.
  2. Although the MOSFETS and the the driving circuit are can working beyond 80V, but the internal TVS is 78V nominal, so E-fuse can not be used beyond 80V.
  3. The Ignite socket is often too high to be safe, Don not plug the power button in it.
  4. This product is for DIY purpose, so we only offer a very limited warranty.

FAQ

Firmware and VESC tool

See also

Main Page