The Uremote and it's standard receiver and Ubox internal receiver

The Uni1 remote (Uremote), can be coupled with an external receiver or with Ubox's daul's internal receiver. Some of our users bought both Ubox and an external receiver, when try to put this external receiver and Ubox to be co-working, their behaver will be confusing.

This article is based on momentary button, the default shipping button.

Steps to make clear Ubox and Uremote link

Check if the Ubox can be clicked on by 1 second then can still on when release the button. If can't, below steps need to hold the button to keep power on do finish them (release button to power off Ubox).

1. Unplug the external receiver if you are using it.
2. Power off Uremote.
3. Power on Ubox only, check if the button LED blinks in 3 seconds after power on, if yes, power off Ubox and skip step 4; If not, do setp4.
4. When Ubox's button LED solid green, click button 8 times, then wait 1second, button LED will off 1 second then on again, then power off Ubox, check button as step 3.
5. On the Uremote, go into setting menu->Receiver Config->Binding->Enter, then power on Ubox, the binding will successful, if not ,try again, if still not, please contact us.
6. When binding succeed, if the Ubox still can't self hold power on after click the button to power on, on the Uremote, go into Uremote's setting menu->Receiver Config->Power Switch, to set the switch type to be 'Momentary'.
7. Check if the power on/off is working now. The normal power with momentary button is click 1 second to on, and press 3 seconds to off, if not, go to step 2 and try again.
8. Check if the RF link is stable, if not check if there is another Ubox or external receiver was bond to this Uremote and is power on now.
9. Leave the external receiver alone if you coupled the Uremote with Ubox. Unless Ubox is radio shielded by it surroundings, this time the external receiver will be helpful to find a best place to make a better link with Uremote.

Steps to make clear Uremote and external receiver link while controlling the Ubox

1. Power off Uremote.
2. Power on Ubox only, when Ubox's button LED solid green, click button 9 times, then wait 1second, button LED will off 1 second then on again, then power off Ubox, check button is no more blink after power on.
3. Power off Ubox, plug in external receiver with a cable in to Ubox, do binding with the Uremote.

Concludes and explain

1. Ubox single 75V don't integrated a receiver, so the external receiver is the only option, so avoided this issue.

See also

Main Page

The power button of Ubox