Difference between revisions of "Ubox V2 100V manual"
From Spintend service and support
(→Ports) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 18: | Line 18: | ||
== Ports == | == Ports == | ||
[[File:Ubox v2 100v function port.png|thumb|center]] | |||
== Specifics == | == Specifics == | ||
Latest revision as of 18:34, 6 May 2022
Ubox V2 100V is a member of our V2 family, the other members are Ubox V2 75V, adapter V2, Uni1 remote V2.
Ubox V2 100V and 75 V are the sister products, they are have same ports and similar functions.
Features
- All the 12V,5V, VCC external ports are recoverable fused, all the HALL, TX&RX are serialized with a resistor, ADC1, ADC2, ADC3 are pulled down with a 22K resistor.
- Independent external VCC, the MCU's VCC isolated, and guarded by a TVS.
- Ignite key and meter supported, fused, for e-scooter/e-bike application.
- Three 12V control ports: front light, horn, and brake light! these ports are separated 2pin sockets.
- Cooling fan socket with 12V power source.
- CAN bus insert power on supported, easy for 4WD configuration.
- External NRF(Bluetooth) socket, to replace the former internal BT module, independent from main UART ports, also A/B switchable.
- VCC is 3.44V, 100% compatible with VESC original FW, no more 3.3V VS 3.44V issue.
- External antenna for internal 2.4 GHz receiver.
- Support both momentary and latching power buttons.
Ports
Specifics
| Voltage | 16-100V, peak voltage should be less than 96V |
| Current | Max 100A/channel, the dual max 200A |
| 12V output | Max 3A(the fan , horn and lights share this current) |
| 5V output | Max output 500mA |
| Power button LED current | Max 15mA |
| Size and weight | 130 x 83x27mm (including screw)/ 396g |
| Cables | Motor cable: 12AWG 12cm / Battery Cable: 10AWG 12cm |
| Current sample | INA240A1 |
| MOSFETS | FDBL0200N100 |
| Warranty | 2 month, limited |
Unique functions
With Uni1 remote (Uremote), the head light, brake light, and horn are controllable.
Brake light control supports external PPM signal input to ESCB.
When without Uremote, several function still can be set by simply click the button.
Limits and cautions
- Since our solution is based on open source VESC, users should fully understand the risks of open source projects. This article only describes the possibility of this build method, and is not responsible for the damage and accidents caused by user themselves.
- This product is for DIY purpose, so we only offer a very limited warranty.
FAQ
See also
The Uremote and it's standard receiver and Ubox internal receiver
